TOP 10 Stratocaster Bridge Cover

Thanks Bob and Mike's great reviews: Bob: * One coil starts with white and finishes with red, the other starts with green and finishes with black * the Red and Green go together and get capped off (tape, shrink wrap, etc..). (In old version is black one for green) * The Black and the cable shield go together and connect to ground. * The White is "hot" and goes to your switch, where the previous p'up connected. I've used several of these p'ups and all have been wired the same way. Yours should come out of the wrapper with black/shield twisted together and red/green twisted together. Just give them and extra shot of solder to make sure they're making good contact. Then, connect as I said above and you'll be rocking in no time. For future reference, you can figure this out pretty quickly if you have an old school analog multi-meter. A humbucker is just two single coils stuck together. So, you have start and finish of one single coil and start and finish on the other. Connect finish of one to the start of the other, and you are left with one pair of start-finish. One of those goes to ground, the other is to hot (to your switch in the strat). Of course, it matters *which* goes to ground or to the switch (it will work either way, but sounds better the *right* way). To get it really rig...